1995 Honda Bros

Drive chain slightly loose (6.2.1d)

Exhaust is leaking but is not excessively noisey Front Cylinder (7.1.1b)

Front Tyre worn close to the legal limit Abnormal Wear (4.1.3(ii))

Brake fluid reservoir slightly corroded Unable to see through sight glass (3.2.B1b)

Coolant leak ()

Drive chain slightly loose (6.2.1d)

Oil leak ()

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Headlamp aim too low (1.6)

Nearside Front shock absorber seal failed and leaking oil (2.3.3)

Nearside Indicator switch does not operate the direction indicators on the side selected (1.5.4)

Nearside Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Offside Front shock absorber seal failed and leaking oil (2.3.3)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear position lamp insecure (1.1.1c)

Rear shock absorber has inadequate damping effect. (2.4.A.3b)

Rear shock absorber seal failed and leaking oil (2.4.A.1c)

Throttle has a significant change in engine speed whilst moving the steering from lock to lock (2.1.4)

Drive chain slightly loose (6.2.1d)

Slight Oil Leak on Engine

Front Brake fluid reservoir slightly corroded Unable to see fluid through site glass (3.2.B1b)

Rear Fairings insecure but not likely to impede the steering (2.1.2e)

Rear shock absorber has a light misting (2.4.A.1c)

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Steering headbearing has excessive free play (2.2.2)

Front Brake fluid reservoir fluid level low (3.2.B1d)

Rear Fairings insecure but not likely to impede the steering (2.1.2e)

Rear shock absorber has a light misting (2.4.A.1c)

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Front Tyre worn close to the legal limit (4.1.3(ii))

Steering headbearing has slight free play (2.2.2)

Front Brake disc(s) excessively worn (3.2.A1l)

Fuel cap mounting flange/sealing method defective (7.2.2c)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Rear mono-shock pivot excessively worn (2.4.B.4)

Brake disc(s) slightly worn (3.2.A1l)

Drive chain slightly tight (6.2.1d)

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)