1988 Rover 213

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear coil spring corroded (2.4.C.1b)

both front inner tie bars slight play.

both rear wheel arches corroded.

nearside front headlight slightly condensation.

spare wheel boot floor corroded.

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

advise front cross member corodded and holed.

watter leak from expansion tank.

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

front crossmember holed

rear of sills and arches poor condition

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Stop lamp not working (1.2.1b)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Sub-frame attachment bracket/mounting corroded and its strength is seriously reduced (2.4.G.1)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

1 of 2 bulbs not working on o/s/r light

Front Brake pad(s) wearing thin (3.5.1g)