1987 Saab 900

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Outer Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting holed next to bottom arm mounting bolt (6.2.2 (d) (i))

Front brakes have light restriction which hinders testing of front bearings

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Rear bumper section missing during time of test with rear member protruing from body

Nearside Rear Vehicle structure is damaged, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Exhaust emits visible black smoke at idle (7.3.A.2b)

Headlamp switch insecure (1.7.1)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp not working on main beam (1.7.5a)

Nearside Rear Body has a sharp edge caused by damage bumper cap missing (6.1.C.1)

Nearside Stop lamp not working (1.2.1b)

Front Power steering pipe(s) or hose(s) has slight seepage from a joint (2.3.3b)

Oil leak

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Body has slight corrosion (6.1.B.2)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Body has slight corrosion (6.1.B.2)

exhaust blow at manifold area when engine is cold

Driver's seat cannot be secured in the upright position. (6.2.A.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Side repeater not working (1.4.A.2c)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside front brake grabbing slightly (3.7.A.2b)

Oil leak

exhaust blow at manifold when engine cold

Nearside Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim too low (1.8)

Offside front brake grabbing slightly (3.7.A.2b)

Oil leak

exhaust blow at manifold when engine cold

Nearside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

slight blow at rear silencer joint

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Windscreen wiper blade deteriorated (8.2.2)

Offside Front Direction indicator incomplete (1.5.A1b)

Offside Front position lamp(s) not working (1.1.A.3b)

Stop lamp not working (1.2.1b)

headlamp switch stiff to use

slight blow at rear exhaust joint