1988 Ford Transit

Brake master cylinder defective but brake still operating (1.1.10 (b) (i))

Brake pedal has insufficient reserve travel (1.1.2 (a))

Brake pipe excessively corroded From Loadsensor to rear Flexi (1.1.11 (c))

Front Brake pipe excessively corroded To rear , rear section into load sensor (1.1.11 (c))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Wheel arch (5.3.6 (a) (i))

Nearside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced Sill back (7.1.1 (a) (i))

Nearside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced Sill (7.1.1 (a) (i))

Offside Front Headlamp lens seriously defective No image (4.1.1 (b) (ii))

Offside Front Inner Seat belt anchorage prescribed area strength or continuity significantly reduced Wheel arch (7.1.1 (a) (i))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Wheel arch (5.3.6 (a) (i))

Offside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced Sill back (7.1.1 (a) (i))

Offside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced Sill (7.1.1 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Passenger's seat insecure Base (6.2.6 (a) (ii)) DANGEROUS

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge 3mm (5.2.3 (e))

Play in propshaft centre bearing ()

Nearside Rear tyre outer wall cracking

Offside Headlamp has a product on the light source but not seriously reducing light output (1.7.5a)

Offside Rear tyre low on pressure

Brake load sensing valve defective and function impaired lever return spring not connected (3.6.E.3)

Offside Front Body has a sharp edge caused by corrosion outer sill (6.1.C.1)

Offside Rear rear brake application uneven 51% lower (3.7.B.2)

Parking brake lever has no reserve travel (3.1.6b)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear tyre outer wall cracking

Offside Headlamp has a product on the light source but not seriously reducing light output (1.7.5a)

Offside Rear tyre low on pressure

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

nearside front tyre inner wall cracking

nearside rear tyre outer wall cracking

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Nearside rear brake binding (3.7.B.1)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Offside Registration plate lamp not working (1.1.C.1d)

Rear rear brake application uneven (3.7.B.2)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

n/s/f tyre outer wall cracking

n/s/r tyre inner wall cracking

Nearside Rear Brake pipe leaking (3.6.A.1)

Rear Brake pipe inadequately clipped (3.6.B.1)

Bonnet cannot be secured in the closed position (8.4.1)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Braking system leaking (3.6.A.1)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)