1988 Austin Mini Mayfair

Brake pipe corroded, covered in grease or other material general / greased (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened corroded (1.1.14 (a) (ii))

Front Service brake binding but not excessively (1.2.1 (f))

Brake pipe corroded, covered in grease or other material general / greased (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened corroded (1.1.14 (a) (ii))

Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Headlamp aim too high (4.1.2 (a))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps both not working (4.7.1 (b) (ii))

Rear Stop lamp(s) all not working (4.3.1 (a) (iii))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor around front seat (6.1.1 (c) (i))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Direction indicator flashing more than 120 times a minute (4.4.4 (a))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced front and rear floor corners (6.1.1 (c) (i))

Offside brake pipe rubbing near subframe mount

Sub-frame pin or bush worn but not resulting in excessive movement all front mounts (5.3.4 (a) (i))

Nearside Outer Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

under side of vehicle undersealed

under vehicle heavily undersealed

Emissions not tested (8.2.1.2 (d))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Windscreen washer not working (3.5 (a))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced door shut area (6.1.1 (c) (i))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

under vehicle heavily undersealed

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced at outer sill (7.1.1 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced at outer sill (7.1.1 (a) (i))

Nearside Front Lower Suspension component ball joint likely to become detached loose on hub (5.3.4 (a) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Nearside Stop lamp not working (1.2.1b)

Nearside Windscreen wiper blade missing (8.2.2)

Offside Brake cable has wires broken and is significantly weakened (3.5.1b)

Offside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Stop lamp not working (1.2.1b)

Offside Windscreen wiper blade missing (8.2.2)

Nearside Lower Front suspension has a suspension lower ball joint securing nut loose to hub (2.5.B.1a) DANGEROUS

Front Exhaust has a minor leak of exhaust gases at manifold (7.1.2)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Fuel system component leaking (7.2.3)

Hazard warning lamps inoperative (1.4.B.1b)

Horn not working (1.6.2a)

Nearside Front Sub-frame attachment bracket/mounting insecure (2.4.G.1)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Rear Stop lamp not working (1.2.1b)

Rear fog lamp not working (1.3.2b)

Front Exhaust has a minor leak of exhaust gases at manifold (7.1.2)

Front Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (7.1.4)

Front position lamp(s) not working (1.1.A.3b)

Nearside Front Body has a sharp edge caused by corrosion (6.1.C.1)

Nearside Front Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Front Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

Front registration plate missing (6.3.1a)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Rear fog lamp not working (1.3.2b)

Offside Registration plate lamp not working (1.1.5c)

Rear Exhaust system not adequately supported (7.1.1)

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Front Headlamp aim too high (1.8)

Nearside Rear Registration plate lamp not working (1.1.5c)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Front Headlamp aim too high (1.8)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

offside rear radius arm siezed

Centre Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Offside Front Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)