1988 Fiat Ducato

Front Sub-frame is fractured and structural rigidity is significantly reduced (6.1.1 (a) (i))

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Jacking point poor repair (6.2.2 (d) (i))

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting SILL (6.2.2 (d) (i))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting SILL (6.2.2 (d) (i))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting jacking point poor repair (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Front spring mount (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting rear spring mount (6.2.2 (d) (i))

Rear Bumper likely to become detached ALL MOUNTING POINTS (6.1.4 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Front Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Offside Front wheel catches wires

heat shield insecure

Front Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front brake pedal has travel

Front Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis jacking point corroded (6.1.1 (c) (i))

Nearside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced centre cross member on rear of cab corroded (6.1.1 (c) (i))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Front Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced wheel arch holed from corrosion (6.1.1 (c) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced crossmember rear of cab corroded (6.1.1 (c) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front brake pedal has travel

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened both fronts on inside (1.1.14 (a) (ii))

generally suffering from corrosion to underbody also covered in a thick black body sealer

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced jacking point floor (6.1.1 (c) (i))

Rear Vehicle structure is deformed and structural rigidity is significantly reduced both ends of the outer sills to body holed from corrosion (6.1.1 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened both fronts on inside (1.1.14 (a) (ii))

generally suffering from corrosion to underbody also covered in a thick black body sealer

Battery insecure (1.9.1)

Emissions not tested see exhaust (7.3.A.1)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Seat belt anchorage prescribed area is excessively corroded end box sill (5.2.6)

Nearside Front Suspension spring mounting prescribed area is excessively corroded inner wheel arch (2.4.A.3)

Nearside Front Suspension spring mounting prescribed area is excessively corroded suspension turret (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded x2 (2.4.A.3)

Offside Front Electrical wiring inadequately supported (1.9.2a)

Offside Front Seat belt anchorage prescribed area is excessively corroded end box sill (5.2.6)

Offside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Suspension spring mounting prescribed area is excessively corroded inner wheel arch (2.4.A.3)

Offside Front Suspension spring mounting prescribed area is excessively corroded suspension turret (2.4.A.3)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Headlamp aim too high (1.8)

Offside Inner Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Suspension spring mounting prescribed area is excessively corroded x2 (2.4.A.3)

Offside front brake excessively fluctuating (3.7.B.3)

Windscreen wiper not operating automatically when switched on doesn't park (8.2.1b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Towball/hitch not fitted at time of test ()

extensive corrosion and welding repairs to vehicle

o/s door handle snapped

rear bumper/tow bar mountings excess corrosion

Exhaust has a minor leak of exhaust gases (7.1.2)

Front both inner wings holed and corroded but not yet effecting the strength or structure of the vehicle

Exhaust system not adequately supported (7.1.1)

Nearside Front Tyre has ply or cords exposed deep age cracks (4.1.D.1b)

Nearside Front Vehicle structure has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings chassis outer rigger (6.1.B.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre has ply or cords exposed deep age cracks (4.1.D.1b)

Nearside Vehicle structure has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings central chassis outer rigger (6.1.B.2)

Offside Front Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Tyre has ply or cords exposed deep age cracks (4.1.D.1b)

Offside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings central chassis outer rigger (6.1.B.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front both inner wings holed and corroded but not yet effecting the strength or structure of the vehicle

Nearside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Rear brake binding slightly

Offside Rear tyre starting to show age cracks

accelerator pedal rubber missing

Body has slight corrosion under body all round (6.1.B.2)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is distorted but not considered excessive (2.4.A.3)

battery insecure

vehicle underside corroded and has had exstensive welding

Front Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front Seat belt anchorage prescribed area is inadequately repaired (5.2.6)

Nearside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Rear Leaf spring anchor bracket corroded and seriously weakened (2.4.B.6d)

Offside Stop lamp adversely affected by the operation of another lamp (1.2.1f)

al suspension components in a rusty condition

brake pipes undersealed

heavily welded and undersealed

steps in a very rusty condition

underside of bonnet rusty

underside undersealed and in a rusty condition

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Headlamp aim too low (1.8)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Upper Stop lamp adversely affected by the operation of another lamp (1.2.1f)

al suspension components in a rusty condition

brake pipes undersealed

steps in a very rusty condition

underside undersealed and in a rusty condition

Offside Front Brake pipe slightly corroded (3.6.B.2c)

front suspension components, front cross member, wheel arches, inner wings and underside of vehicle in a rusty condition.

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Rear fog lamp not working (1.3.2b)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

rear brake binding (3.7.B.1)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

front suspension components, front cross member, all wheel arches, and underside of vehicle in a very rusty condition.

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Headlamp not working on main beam (1.7.5a)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Front Direction indicator adversely affected by the operation of another lamp (1.4.A.2h)

Nearside Front Direction indicator not working (1.4.A.2c)

Nearside Front Front position lamp(s) insecure (1.1.A.3a)

Rear Brake load sensing valve linkage defective and function impaired (3.6.E.3)

Rear Rear fog lamp not working (1.3.2b)

Rear fog lamp switch missing (1.3.1a)