1987 Fiat Ducato

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

underbody corroded

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i))

Nearside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

underbody corroded

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

front inner wheel arches corroded

inner sills corroded

rear tyres cracking/perishing

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Brake hose slightly deteriorated all brake hoses (1.1.12 (b) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

front inner wings corroded (not within 30cm of suspension mountings)

offside lower inner sill corroded

rear cross member corroded (no towbar fitted at time of test)

underbody corroded

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring hanger (5.3.6 (a) (i))

underbody corroded

Exhaust system insecure (6.1.2 (a))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength cross member (various holes) (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring hanger (5.3.6 (a) (i))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (various holes) (5.3.6 (a) (i))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength crossmember (various holes) (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring hanger (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (various holes) (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Rear Brakes imbalanced across an axle 42% (1.2.1 (b) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen wiper not working (3.4 (a))

Driver's seat insecure (6.2.5 (a) (ii)) DANGEROUS

underbody corroded

Central Front Oil leak ()

Offside Front Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings outer sill (6.1.B.2)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner wing/sill (6.1.B.2)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings outer sill adjacent b pillar (6.1.B.2)

Offside Front Body or chassis is damaged, seriously affecting its strength within 30cm of the body mountings floor (6.1.B.2)

Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner sill (6.1.B.2)

Rear Exhaust system not adequately supported rubbers split or missing (7.1.1)

Battery insecure

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Inner Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Fuel system component leaking (7.2.3)

Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Battery insecure

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Inner Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Battery insecure

Engine/gearbox mounting(s) defective

Suspension joint nearside lower dust cover split/missing

Suspension joint nearside upper dust cover split/missing

both front inner wings showing signs of corrosion

n/s and o/s inner sill box sections corroded

o/s track rod end rubber boot split

wiper linkages worn

Brakes imbalanced across an axle (3.7.B.5b)

Emissions not tested (7.0)

Exhaust system not adequately supported (7.1.1)

Fuel cap/sealing device does not fasten securely by positive means (7.2.4b)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Headlamp aim aimed so that it dazzles other road users (1.8.A.1a)

Offside Headlamp insecure (1.7.3)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear wheel bearing rough when rotated (2.6.1)

Battery insecure

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Engine/gearbox mounting(s) defective

Suspension joint nearside lower dust cover split/missing

Suspension joint nearside upper dust cover split/missing

both front inner wings showing signs of corrosion

n/s and o/s inner sill box sections corroded

o/s track rod end rubber boot split

wiper linkages worn

Brake load sensing valve linkage stiff (3.6.E.3)

Nearside Body has slight corrosion (6.1.B.2)

Nearside Front Body has slight corrosion (6.1.B.2)

Offside Body has slight corrosion (6.1.B.2)

Offside Front Body has slight corrosion (6.1.B.2)

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Rear wheel bearing has slight play (2.6.2)

Offside Rear wheel bearing (2.6.1)

engine/gearbox mounting(s) defective

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Front position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Front Front position lamp(s) not in good working order (function impaired) (1.1.4a)

Rear Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Registration plate lamp not working (1.1.5c)