1988 Fiat Panda

Offside Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Nearside Rear Position lamp adversely affected by the operation of another lamp flashing when the indicator is operated (4.2.3 (c))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Offside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill/floor (5.3.6 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear rear panel and floor corroded

under side of vehicle heavily under sealed restricting view of possible corrosion

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Stop lamp(s) all not working (4.3.1 (a) (iii))

Brake pipe corroded, covered in grease or other material all under side covered in under seal (1.1.11 (c))

heavily under sealed underside of vehicle

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Brake pipe corroded, covered in grease or other material all under side covered in under seal (1.1.11 (c))

heavily under sealed underside of vehicle

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside rear brake recording little or no effort (3.7.B.5a)

Service brake: efficiency below requirements (3.7.B.7)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Inner Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear rear brake binding (3.7.B.1)

front spotlights insecure

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)