1988 Mercedes Motor Home

Brake master cylinder/servo mounting prescribed area is excessively corroded (1.1.21 (e) (i))

Drag link end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt Both (2.1.3 (g) (ii))

Horn not working (7.7 (a))

Nearside Headlamp light intensity severely reduced (4.1.4 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Steering linkage ball joint ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Windscreen wiper not working (3.4 (a))

Offside Front Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp light intensity severely reduced (4.1.4 (a))

Offside Rear Upper Position lamp not working (4.2.1 (a) (ii))

Offside Steering linkage ball joint ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Windscreen wiper not working (3.4 (a))

Rear Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Exhaust corroded

Fan belt loose

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Nearside Front Electrical wiring inadequately secured (4.11 (a) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Upper Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

Offside Front Leaf spring has slight wear in a shackle pin and/or bush (5.3.4 (a) (i))

Suspension components has slight corrosion

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Windscreen slight damage

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt both sides (2.2.C.1c)

Nearside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt both sides (2.2.C.1c)

Drag link end ball joint dust cover deteriorated, but preventing the ingress of dirt both (2.2.C.1c)

Track rod end ball joint dust cover damaged, but preventing the ingress of dirt both (2.2.C.1c)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

rear brake application uneven (3.7.B.2)

Drag link end ball joint dust cover deteriorated, but preventing the ingress of dirt both (2.2.C.1c)

Track rod end ball joint dust cover damaged, but preventing the ingress of dirt both (2.2.C.1c)

corrosion behind n/s headlamp

front exhaust has slight leak of gasses

wipers do not turn off

Brake master cylinder/servo mounting prescribed area is excessively corroded behind o/s headlamp (3.6.C.3)

Offside Headlamp not working on main beam (1.7.5a)

Offside Rear Brakes imbalanced across an axle (3.7.B.5b)

Offside Rear fog lamp not working (1.3.2b)

Offside rear brake application uneven (3.7.B.2)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

corrosion behind n/s headlamp

front exhaust has slight leak of gasses

wipers do not turn off

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Indicator tell tale inoperative (1.4.A.2a)

Rear fog lamp not working (1.3.2b)

Service brake: efficiency below requirements (3.7.B.7)

Exhaust has a minor leak of exhaust gases (7.1.2)

Throttle sticking

Fuel system component leaking (7.2.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Exhaust system not adequately supported (7.1.1)

Service brake: efficiency below requirements (3.7.B.7)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Service brake: efficiency below requirements (3.7.B.7)

Slight run out n/s rear brake

Brake load sensing valve linkage obviously incorrectly adjusted (3.6.E.3)

Nearside Headlamp aim too high (1.8)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too low and too far to the right. (1.8)

Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Service brake: efficiency below requirements (3.7.B.7)

Slight run out n/s rear brake

An item not tested (Manual)

Brakes imbalanced across an axle (3.7.B.5b)

Drag link end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside front brake binding (3.7.B.1)

Offside rear brake binding (3.7.B.1)

Service brake: efficiency below requirements (3.7.B.7)

Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Brake load sensing valve has been disconnected and was fitted as standard (3.6.E.2) DANGEROUS

Obligatory mirror seriously obscured affecting the rear view (8.1.2a) DANGEROUS

Front brake discs worn & rusty

Throttle sticks slightly

advise all over body rust uderside

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Nearside Rear Shock absorber has a slightly reduced damping effect (2.7.5)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded (3.6.C.3)

Nearside Rear Shock absorber has a slightly reduced damping effect (2.7.5)