2003 Peugeot 206

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords outer wall (5.2.3 (d) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Service brake lagging in operation (1.2.1 (d))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting SILL (6.2.2 (d) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Both Rear Tyres are balding on the inner edges

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Horn not working (1.6.2a)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Direction indicator incorrect colour (1.4.A.2f)

Offside Rear Direction indicator incorrect colour (1.4.A.2f)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Horn not working (1.6.2a)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Seat belt locking mechanism does not secure or release (5.2.5a)

rear wheel bearing slighty noisey