2003 Peugeot 206

Headlamp has a product on the lens but not seriously reducing light output bothside front , lens should be cleaned (4.1.4 (b))

Rear load sensing valve stiff.

Suspension arm pin or bush worn but not resulting in excessive movement bothside front rear bush dibonding, should replace (5.3.4 (a) (i))

engine and gearbox seeping oil.

Offside Front Side repeater not working bulb broken. (4.4.1 (a) (ii))

Position lamp not working bothside front (4.2.1 (a) (ii))

Nearside Front Tyre has ply or cords exposed outer shoulder. (5.2.3 (d) (ii)) DANGEROUS

Headlamp has a product on the lens but not seriously reducing light output bothside front , lens should be cleaned (4.1.4 (b))

Rear load sensing valve stiff.

Suspension arm pin or bush worn but not resulting in excessive movement bothside front rear bush dibonding, should replace (5.3.4 (a) (i))

engine and gearbox seeping oil.

Nearside Rear Wheel bearing slightly noisy should replace. (5.1.3 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear parking brake noisy on application.

Suspension arm pin or bush worn but not resulting in excessive movement bothside front lower craking and dibonding. (5.3.4 (a) (i))

Headlamp has a product on the lens so that the light output is severely reduced bothside front lens badly tarnished, can clean or replace. (4.1.4 (b))

Horn not working (7.7 (a))

Nearside Rear Wheel bearing slightly noisy should replace. (5.1.3 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear parking brake noisy on application.

Suspension arm pin or bush worn but not resulting in excessive movement bothside front lower craking and dibonding. (5.3.4 (a) (i))

Headlamp has a product on the lens but not seriously reducing light output bothside front lens should be cleaned, a.s.a.p, marginal; pass. (4.1.4 (b))

Nearside Brake pipe corroded, covered in grease or other material center section corroded in places. (1.1.11 (c))

Nearside Rear Wheel bearing slightly noisy marginal pass, should replace. (5.1.3 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material to load sensing valve , badly corroded, marginal pass,should replace a.s.a.p. (1.1.11 (c))

Suspension arm pin or bush worn but not resulting in excessive movement bothside front wishbone rear bush dibonding. (5.3.4 (a) (i))

horn sounds, little harsh should replace.

Front Exhaust has a minor leak of exhaust gases also badly corroded at joints. (6.1.2 (a))

Nearside Rear Brake pipe corroded, covered in grease or other material in place and offside rear to load sensing valve. (1.1.11 (c))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output aim/pattern not very defined. (4.1.4 (b))

Offside Front Tyre slightly damaged/cracking or perishing inner and outer should replace. (5.2.3 (d) (ii))

Play in steering rack inner joint(s) and lightly knocking. ()

Rear Brake load sensing valve stiff (1.1.17 (c) (ii))

Suspension arm pin or bush worn but not resulting in excessive movement bothside front and dibonding. (5.3.4 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Upper Anti-roll bar ball joint dust cover severely deteriorated pin hole split (5.3.4 (b) (i))

Nearside Lower Oil leak, but not excessive (8.4.1 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material load sensing valve (1.1.11 (c))

Horn not working (7.7 (a) (ii))

Offside Front Headlamp aim projected beam image is obviously incorrect not visible image (4.1.2 (c))

Offside Front Lower Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Upper Anti-roll bar ball joint dust cover severely deteriorated pin hole split (5.3.4 (b) (i))

Nearside Lower Oil leak, but not excessive (8.4.1 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material load sensing valve (1.1.11 (c))

Anti-roll bar linkage ball joint has slight play bothside front, should replace. (5.3.4 (a) (i))

Front Exhaust has a minor leak of exhaust gases down pipe to joints pin holed ,should be repaired or replace. (6.1.2 (a))

Nearside Front Brake pipe corroded, covered in grease or other material to rear brake pipe corroding in places. (1.1.11 (c))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Rear Brake pipe corroded, covered in grease or other material to load sensing valve corroded, should replace. (1.1.11 (c))

Suspension arm pin or bush worn but not resulting in excessive movement bothside front rear bush dibonting, should replace. (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material to load sensing valve corroded (1.1.11 (c))

Oil leak, but not excessive seeping from gearbox (8.4.1 (a) (i))

Suspension arm pin or bush worn but not resulting in excessive movement both side front lower arm rear bushes debonding (5.3.4 (a) (i))

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Direction indicator slightly discoloured both side front pale (4.4.3 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened both side (1.1.14 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material to load sensing valve corroded (1.1.11 (c))

Oil leak, but not excessive seeping from engine (8.4.1 (a) (i))

Oil leak, but not excessive seeping from gearbox (8.4.1 (a) (i))

Suspension arm pin or bush worn but not resulting in excessive movement both side front lower arm rear bushes debonding (5.3.4 (a) (i))

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement both side rear bush (2.4.G.2)

Front brake disc worn, pitted or scored, but not seriously weakened both side (3.5.1i)

Rear Brake load sensing valve stiff (3.6.E.3)

bothside front tyre/s shoulder/s worn thin.

nearside front wishbone front bush worn-and rear bush dibonding.

offside front wishbone rear bush dibonding.

Rear Brake load sensing valve linkage stiff (3.6.E.3)

bothside front lower front bush worn and rear bush dibonding.

bothside rear tyre/s outer wall edge/s cracking.

comcover gasket leak oil- should replace.

Exhaust has a minor leak of exhaust gases (7.1.2)

nearside front lower arm rear bush dibonding.and front bush worn.

offside front lower arm rear bush dibonding,and front bush worn.

Brake load sensing valve stiff (3.6.E.3)

Nearside Front Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

rear silencer outer skin poor condition.

rear silencer corroded

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Direction indicator incorrect colour (1.4.A.2f)

Nearside Stop lamp not working (1.2.1b)