2003 Peugeot 206

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Tyre has ply or cords damaged (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Lower Suspension arm locating pin insecure loose in hub (2.4.G.3a)

Nearside Rear tyre low on pressure

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases downpipe at the gearbox support bracket (7.1.2)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim too low (1.8)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2) DANGEROUS

Nearside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Offside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Offside Rear Brake load sensing valve stiff (3.6.E.3)

Nearside Front Brake hose twisted (found during steering lock to lock check) hose to caliper (2.2.D.2b)

Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Lower Shock absorber has an excessively worn bush (2.7.4)

Offside Rear Brake load sensing valve stiff (3.6.E.3)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nail in offside rear tyre

Nearside Front Track rod end slightly corroded but serviceable (2.2.C.1d)

Nearside Rear Trailing arm corroded but not seriously weakened (2.4.G.1)

Offside Front Track rod end slightly corroded but serviceable (2.2.C.1d)

Offside Rear Trailing arm corroded but not seriously weakened (2.4.G.1)

headlamp aim was way too low, now adjusted to correct aim, o/s/f aim is slighty too far to the left, n/s/f aim is too far to the right.

n/s/r tyre has slight cracking on inner sidewall, and a slight tear on outer sidewall. n/s/f tyre has a slight cut, and a slight tear on inner sidewall.

remove items off of rear seat, to inspect seatbelts in future.

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Stop lamp adversely affected by the operation of another lamp (1.2.1f)

Rear Seat belt retracting mechanism defective (5.2.5b)

Brake load sensing valve linkage seized (3.6.E.3)

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Stop lamp not working (1.2.1b)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Steering rack gaiter insecure (2.2.D.2d)

Power steering component(s) leaking from a failed seal (2.3.3b)

Power steering inoperative (2.3.3a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Steering system fouling (2.2.D.2a)

Nearside Stop lamp not working (1.2.1b)

Offside Stop lamp not working (1.2.1b)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Rear Stop lamp not working (1.2.1b)