2010 Renault Clio

Front Shock absorber slight corroded

Front Tyre worn close to legal limit/worn on edge Both side tyres wearing smooth on inner edges (5.2.3 (e))

Fuel Pipe/s corroded Front to rear slightly corroded ()

Front Sub-frame corroded and seriously weakened Nearside front excessive corroded (5.3.3 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Front Shock absorber slight corroded

Front Tyre worn close to legal limit/worn on edge Both side tyres wearing smooth on inner edges (5.2.3 (e))

Fuel Pipe/s corroded Front to rear slightly corroded ()

Offside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

Nearside Rear Tyre worn close to legal limit/worn on edge @ 2.7 mm and scrubbed on outer edge. (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge @ 2.4 mm and slightly scrubbed on outer edge. (5.2.3 (e))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge @ 2.7 mm and scrubbed on outer edge. (5.2.3 (e))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge Scrubbed on both edges. (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge @ 2.4 mm and slightly scrubbed on outer edge. (5.2.3 (e))

Rear Exhaust mounting defective (6.1.2 (a))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Slight play at nearside rack end inner joint

Nearside Stop lamp not working (1.2.1b)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)