2012 Toyota Prius

Exhaust mounting defective (6.1.2 (a))

Nearside Front Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Exhaust mounting defective (6.1.2 (a))

Nearside Front Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Headlamp has a product on the lens but not seriously reducing light output Both side (4.1.4 (b))

Under tray fitted

Offside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre obviously under inflated (5.2.3 (l))

Offside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Front Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Headlamp not working on main beam (1.7.5a)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Registration plate lamp not working (1.1.C.1d)

Front registration plate delaminated but not likely to be misread (6.3.1d)

Front registration plate delaminated but not likely to be misread (6.3.1d)

Offside Front Headlamp not working on main beam (1.7.5a)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Registration plate lamp not working (1.1.C.1d)