2013 Peugeot 208

Nearside Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust has a minor leak of exhaust gases FRONT / REAR (6.1.2 (a))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge 2.2 mm (5.2.3 (e))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Headlamp levelling device inoperative (4.1.5 (a))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Coil spring mounting corroded but not seriously weakened (5.3.1 (b) (i))

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Rear Tyre slightly damaged/cracking or perishing cracking in tread area (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing cracking in tread area (5.2.3 (d) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake performance not tested (1.2.1 (g))

Exhaust system insecure (6.1.2 (a))

Nearside Front Service brake excessively binding (1.2.1 (f))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Exhaust mounting defective (6.1.2 (a))

Rear Sub-frame corroded but not seriously weakened UNDER PLASTIC COVER. (5.3.3 (b) (i))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Rear Exhaust mounting defective (6.1.2 (a))

Rear Sub-frame corroded but not seriously weakened UNDER PLASTIC COVER. (5.3.3 (b) (i))

exhaust bracket corroded and detached,but system is supported.