2010 Hyundai I30

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp insecure (4.1.1 (c))

Rear Registration plate lamp likely to become detached (4.7.1 (c) (ii))

Front Lower Oil leak, but not excessive (8.4.1 (a) (i))

Front Electronic power steering warning lamp indicates a system malfunction (2.6 (a))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps both lamps (4.7.1 (b) (ii))

Front Lower Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Nearside Front Outer Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Outer Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Parking brake lever defective so that it cannot be satisfactorily operated (1.1.6 (d))

Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Steering rack has excessive free play detected at the steering wheel (steering rack fitted) (2.3 (a) (i))

Front Headlamp aim too low (4.1.2 (a))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

hand rake effort poor on nearside

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

hand rake effort poor on nearside

Offside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear tyres wearing

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge worn on the inner edge (5.2.3 (e))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge worn on the inner edge (5.2.3 (e))

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front coil spring broken (2.4.C.1a)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Tyre tread depth below requirements of 1.6mm both front (4.1.E.1)

Nearside Front Headlamp aim too low (1.8)

Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front Headlamp aim too low (1.8)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)