2011 Ford S-max

Rear Lower Suspension arm corroded but not seriously weakened both side (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Lower Suspension arm corroded but not seriously weakened BOTH SIDES (5.3.3 (b) (i))

Brake pad(s) wearing thin on limit (1.1.13 (a) (ii))

Coil spring corroded both rears (5.3.1 (b) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Coil spring corroded both rears (5.3.1 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Coil spring corroded both rears (5.3.1 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Central Rear Passenger seat(s) missing at time of test

Nearside Rear Passenger seat(s) missing at time of test

Offside Rear Passenger seat(s) missing at time of test

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Central stop lamp not working

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Exhaust heat shield loose

Offside Front Headlamp aim too high (1.8)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

rear seats folded down

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components