2003 Subaru Forester

Nearside Front Bumper insecure (6.1.4 (a) (i))

Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Front Obligatory indirect vision device insecure (3.3 (b) (ii))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Headlamp lens seriously defective (4.1.1 (b) (ii))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Front Obligatory indirect vision device insecure (3.3 (b) (ii))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Anti-roll bar attachment bracket/mounting fractured (5.3.3 (b) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Outer Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Anti-roll bar attachment bracket/mounting insecure Broken anti roll bar bracket (5.3.3 (a) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Outer Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

exhaust system corroded

Nearside Indicator tell tale inoperative (1.4.A.2a)

Nearside Rear Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Stop lamp not working (1.2.1b)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Offside Front Headlamp aim too high (1.8)

exhaust system corroded

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Rear tyre outer wall deterioated

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Rear tyre outer wall deterioated

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Registration plate lamp not working (1.1.C.1d)

EML indicates a fault

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear coil spring corroded (2.4.C.1b)

Nearside Rear coil spring corroded (2.4.C.1b)

NEAR SIDE REAR TYRE OUTER WALL SCRUBBED (POSSIBLE DRIVEN ON PUNTURE)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

offside front tyre edge worn