2006 Toyota Aygo

Corrosion to rear suspension components

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Corrosion to rear suspension components

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Exhaust mounting defective (6.1.2 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Tyre worn close to legal limit/worn on edge Both (5.2.3 (e))

Offside Registration plate lamp missing in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Headlamp lens slightly defective Both (4.1.1 (b) (i))

Central Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Road wheel slightly distorted (5.2.2 (c) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear quarter panel has a large area repaired with a thick layer of body filler that is cracking & flaking

Water-pump weeping coolant

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Hazard warning switch inoperative (4.4.2 (a) (ii))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Central Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Engine oil level was below minimum, 0.5Ltr added to enable MOT test.

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Road wheel slightly distorted (5.2.2 (c) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear quarter panel has a large area repaired with a thick layer of body filler that is cracking & flaking

Rear Exhaust mounting defective silencer input pipe broken completely around the weld (6.1.2 (a))

Tyre obviously under inflated All four tyres were under 20psi, inflated to 30psi (5.2.3 (l))

Water-pump weeping coolant

Nearside Stop lamp not working (1.2.1b)

Rear fog lamp not working (1.3.2b)

Nearside Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Stop lamp not working (1.2.1b)

Offside Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)