2007 Honda CBF1000

Rear Lower Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Offside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Drive chain slightly loose (6.1.7 (c) (i))

Rear Lower Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Shock absorber has a light misting of oil (5.3.2 (b))

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

Drive chain slightly loose (6.1.7 (c) (i))

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

Front Brake binding but not excessively (1.2.1 (f))

Nearside Front Shock absorber has a light misting of oil (5.3.2 (b))

Central Front Steering movement slightly 'notchy' (2.2.1a)

Nearside Front Front shock absorber has light misting of stanchion (2.3.3)

Stop lamp does not illuminate immediately a brake applies rear brake switch (1.3.1a)

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Tyre worn close to the legal limit (4.1.3(ii))

Advise slight corrosion exhaust.

Advise slight corrosion swingarm.

Rear Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Offside Handlebar handgrip not secure to handlebars. (2.1.1c)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Advise front wheel tight to turn.

Advise slight corrosion exhaust.

Advise slight corrosion swingarm.

Headlamp aim too high (1.6)

Rear Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Steering movement slightly 'notchy' (2.2.1b)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Steering movement slightly 'notchy' (2.2.1b)

Front Steering movement slightly 'notchy' (2.2.1a)

Rear Brake component is slightly distorted (3.1.5)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))