2004 Honda Jazz

Emissions unable to be completed (8.2.1.2 (d))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Inner Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected seal area near axle bolt (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Inner Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected seal area near axle bolt (5.3.6 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened see signs of heat from binding (1.1.14 (a) (ii))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Offside Front Lower Anti-roll bar likely to become detached (5.3.3 (a) (ii)) DANGEROUS

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Upper Top bush or bearing has slight wear or free play

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Upper Top bush or bearing has slight wear or free play

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Rear wheel bearing rough when rotated (2.6.1)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)