2006 Subaru Impreza

Central Rear Suspension cradle corroded

Nearside Front Upper Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Wiper worn

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Sub frame corroded

Headlamp warning light on dash

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Nearside Front Tyre slightly damaged (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged (5.2.3 (d) (ii))

Brake pipe corroded, covered in grease or other material all round (1.1.11 (c))

Nearside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Power steering close to minimum mark (2.1.5 (b) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Power steering close to minimum mark (2.1.5 (b) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Inner Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit and worn unevenly on edges (4.1.E.1)

Offside Front Inner Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit and worn unevenly on edges (4.1.E.1)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Inner Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit and worn unevenly on edges (4.1.E.1)

Offside Front Inner Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit and worn unevenly on edges (4.1.E.1)

Nearside Rear tyre perished in tread

Front Service brake juddering slightly (3.7.C.2)

Nail in nearside rear tyre

Rear Service brake juddering slightly (3.7.C.2)

Service brake juddering slightly (3.7.C.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Service brake juddering slightly (3.7.C.2)

Centre Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Service brake juddering slightly (3.7.C.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)