2013 Mercedes-benz C

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Parking brake only just met requirements

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Tyre slightly damaged/cracking or perishing X4 (5.2.3 (d) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Rear Nail in tyre

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Nail in tyre

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii))

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii))

emissions to clean to test

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)