2003 Ford Transit

Front Exhaust has a minor leak of exhaust gases flexi damaged (6.1.2 (a))

Front Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Track rod end slightly misaligned (2.1.3 (e))

Nearside Front under sill corroded and damaged

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front inner sill corroded

Front Exhaust has a minor leak of exhaust gases flexy pipe (6.1.2 (a))

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting floor/step (6.2.2 (d) (i))

Nearside Front Upper Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner w/arch (6.2.2 (d) (i))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting as chalked (6.2.2 (d) (i))

Offside Front Bumper insecure (6.1.4 (a) (i))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting as chalked (6.2.2 (d) (i))

Windscreen washer not working (3.5 (a))

Front Exhaust has a minor leak of exhaust gases flexy (6.1.2 (a))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced OUTER CENTER SEAL CORRODED (6.1.1 (c) (i))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner arch to step join (6.1.1 (c) (i))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outrigger next to leaf spring mount (6.2.2 (d) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Inner Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced chassis both sides (6.1.1 (c) (i))

Front Exhaust has a minor leak of exhaust gases flexy pipe (6.1.2 (a))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

vehicles under body has slight corrosion

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Front Suspension arm pin or bush likely to become detached both wishbone arm bush (5.3.4 (a) (ii)) DANGEROUS

Nearside Rear Tyre slightly damaged/cracking or perishing cracking (5.2.3 (d) (ii))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Fluid leak, but not excessive (8.4.1 (a) (i))

slight corrosion on under body

Central Front Seat belt damaged but webbing not significantly weakened (5.2.2a)

Front Brake pad(s) wearing thin (3.5.1g)

Oil leak ()

Nearside Front Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Offside Rear Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Rear fog lamp not working (1.3.2b)

Central Front Seat belt damaged but webbing not significantly weakened (5.2.2a)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Oil leak ()

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Vehicles internal headlight adjuster altered to recheck lights ()

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Stop lamp not working (1.2.1b)

Rear registration plate deteriorated (6.3.1d)

Vehicles internal headlight adjuster altered to recheck lights ()

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Centre Front Seat belt stitching slightly frayed (5.2.2b)

brake pedal rubber worn

Centre Front Seat belt stitching slightly frayed (5.2.2b)

Power steering fluid level below minimum (2.3.1)

brake pedal rubber worn

Centre Seat belt damaged but webbing not significantly weakened (5.2.2a)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Power steering fluid level below minimum (2.3.1)

Centre Seat belt damaged but webbing not significantly weakened (5.2.2a)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Stop lamp not working (1.2.1b)

Offside Rear fog lamp not working (1.3.2b)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Rear wheel bearing has excessive play (2.6.2)

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)