2006 Mazda RX-8

Electronic stability control warning lamp indicates a fault (7.12 (e))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Coil spring insecure (5.3.1 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill to floor (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill to floor (5.3.6 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Anti-roll bar linkage likely to become detached (5.3.3 (a) (ii)) DANGEROUS

Offside Front Anti-roll bar linkage likely to become detached (5.3.3 (a) (ii)) DANGEROUS

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Exhaust has a minor leak of exhaust gases Silencer (6.1.2 (a))

Rear suspension components corroded

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

rear sub frame corroded

rear suspension corroded

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

rear sub frame corroded

rear suspension corroded

Offside engine mounting deteriorated, but not resulting in excessive movement (6.1.D.1a)

Front brake pads are worn low.