2006 Ford Ka

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Body panel insecure wheel arch (6.2.1 (a) (i))

Nearside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Upper Macpherson strut pin or bush excessively worn (5.3.4 (a) (i))

Front Bonnet primary retaining device slightly deteriorated handle (3.1 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front arch liner not fully secure, rubbing

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced surface corrosion rear and front inner sills corners (6.1.1 (c) (i))

General corrosion to under body and suspension components

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim unable to be tested (4.1.2 (b))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

General corrosion to under body and suspension components

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Headlamp aim not tested (4.1.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Windscreen wiper blade defective (3.4 (b) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Surface corrosion on underside of vehicle

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Both front tyres starting to split

Offside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Headlamp aim too low (1.8)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Rear Stop lamp not working (1.2.1b)

both rear tyres age cracking

both rear tyres age cracking