2010 Nissan Pixo

Rear Suspension arm corroded but not seriously weakened both side (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both side (5.3.6 (a) (i))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Position lamp not working BOTH (4.2.1 (a) (ii))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Wheel bearing rough when rotated DROVER SIDE (5.1.3 (b) (i))

Offside Rear Direction indicator not working (4.4.1 (a) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear suspension mounting area slightly corroded

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Outer Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Outer Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear suspension mounting area slightly corroded

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Brake lining(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake lining(s) wearing thin (1.1.13 (a) (ii))

Offside Front Outer Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Brake pipe corroded, covered in grease or other material some (1.1.11 (c))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear (5.3.4 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Front brake disc worn, pitted or scored, but not seriously weakened both (3.5.1i)

o/s/f tyre wearing on edges

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Inner Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)