2013 Peugeot 107

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced Around jacking point (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive Both sides (5.3.6 (a) (i))

Both headlamp lenses would benefit from a polish

Nearside Rear Tyre worn close to legal limit/worn on edge Inner edge (5.2.3 (e))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement n/s & o/s (5.3.4 (a) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement n/s & o/s ( rearmost ) (5.3.4 (a) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Brake pipe corroded, covered in grease or other material @ flexi union (1.1.11 (c))

Rear Exhaust mounting defective silencer hanging bracket corroded (6.1.2 (a))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement n/s & o/s (5.3.4 (a) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement n/s & o/s ( rearmost ) (5.3.4 (a) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Brake pipe corroded, covered in grease or other material @ flexi union (1.1.11 (c))

Rear Exhaust mounting defective silencer hanging bracket corroded (6.1.2 (a))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Front front tires becoming low on tread wear

Central Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Front front tires becoming low on tread wear