2007 Hyundai Coupe

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brake drum back plate insecure x2 (1.1.14 (d))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Coil spring corroded x4 (5.3.1 (b) (i))

Front Registration plate insecure but not likely to fall off slight damage (0.1 (a))

Front Shock absorbers has slight external damage to the casing both corrosion (5.3.2 (b))

Rear Outer Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

Rear second hand rear sub frame fitted and covered in underseal

front sub frame,front suspension arms,rear trailing arms,chassis all have surface rust

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Rear Exhaust has a major leak of exhaust gases joint (6.1.2 (a))

Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Coil spring corroded x4 (5.3.1 (b) (i))

Front Registration plate insecure but not likely to fall off slight damage (0.1 (a))

Front Shock absorbers has slight external damage to the casing both corrosion (5.3.2 (b))

Rear Outer Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

front sub frame,front suspension arms,rear trailing arms,chassis all have surface rust

Exhaust has a minor leak of exhaust gases slight leak at rear section and center section to middle section joint (6.1.2 (a))

Rear rear suspension components , os shock absorber ,rear anti roll bar, suspension arms all have surface rust

front and rear subframe have light surface corrosion

Front Registration plate missing (0.1 (a))

Nearside Front Inner Tyre has a bulge, caused by separation or partial failure of its structure inner sidewall 215/45/17 (5.2.3 (d) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases slight leak at rear section and center section to middle section joint (6.1.2 (a))

Offside Front Outer Tyre worn close to legal limit/worn on edge tyre wearing unevenly around outer edge (5.2.3 (e))

Rear rear suspension components , os shock absorber ,rear anti roll bar, suspension arms all have surface rust

front and rear subframe have light surface corrosion

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Service brake lagging in operation (1.2.1 (d))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Exhaust has a minor leak of exhaust gases (Flexi) (7.1.2)

Handbrake only just met requirements

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

frt discs in poor condion on inside

o/s/r brake in poor condition on outside

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

front b/pads 75% worn

o/s/f tyre 3mm

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

front b/pads 75% worn

o/s/f tyre 3mm