2007 Hyundai Coupe

Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Play in steering rack inner joint(s)

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

underside is corroded in places

Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Play in steering rack inner joint(s)

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

underside is corroded in places

Nearside Front Headlamp aim projected beam image is obviously incorrect European spec headlight as kick goes the wrong way (4.1.2 (c))

Nearside Front Headlamp aim too high (4.1.2 (a))

Offside Front Headlamp aim projected beam image is obviously incorrect European spec headlight as kick is the wrong way round (4.1.2 (c))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Coolant level below minimum

Front Coil spring corroded Both (5.3.1 (b) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Arm rear bush (5.3.4 (a) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Rear Inner Vehicle structure is corroded but structural rigidity is not significantly reduced Sill (6.1.1 (c) (i))

Nearside Rear Outer Body component slightly loose Arch corroded (6.2.1 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Suspension arm corroded but not seriously weakened Trailing arm (5.3.3 (b) (i))

Nearside Rear Upper Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Arm rear bush (5.3.4 (a) (i))

Offside Inner Vehicle structure is corroded but structural rigidity is not significantly reduced Sill (6.1.1 (c) (i))

Offside Rear Inner Road wheel slightly distorted (5.2.2 (c) (i))

Offside Rear Outer Body component slightly loose Arch corroded (6.2.1 (a) (i))

Offside Rear Registration plate lamp very dim

Offside Rear Suspension arm corroded but not seriously weakened Trailing arm (5.3.3 (b) (i))

Oil leak, but not excessive Engine oil leak (8.4.1 (a) (i))

Rear Coil spring corroded Both (5.3.1 (b) (i))

Rear Macpherson strut corroded but not seriously weakened Both (5.3.3 (b) (i))

Rear Registration plate deteriorated but not likely to be misread Cracked (0.1 (b))

Front Exhaust has a major leak of exhaust gases Flexible joint. (6.1.2 (a))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre worn close to legal limit/worn on edge 2mm. (5.2.3 (e))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords Outer sidewall (5.2.3 (d) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Steering linkage ball joint has slight play (2.1.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Nail in tyre X2

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Power steering fluid level below minimum (2.1.5 (b) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Suspension component pin or bush slightly worn (5.3.4 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Tyre worn close to legal limit/worn on edge BOTH (5.2.3 (e))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Tyre worn close to legal limit/worn on edge BOTH (5.2.3 (e))

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)