2008 Ford Ka

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Oil leak, but not excessive engine and gearbox (8.4.1 (a) (i))

Windscreen wiper blade defective both (3.4 (b) (i))

inner sills,chassis,floors and steps corroded

Offside Front Steering system fouling (2.1.4 (a))

Offside Headlamp aim unable to be tested (4.1.2 (b))

Offside Headlamp not working on dipped beam also levelling not tested (4.1.1 (a) (ii))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sills (5.3.6 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Oil leak, but not excessive engine and gearbox (8.4.1 (a) (i))

Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Windscreen wiper blade defective both (3.4 (b) (i))

corrosion throughout vehicle

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front condensation in headlamp unit

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced outer sill end corroding (6.1.1 (c) (i))

Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Brake valve leaking such that brake functionality is affected brake fluid leaking from ABS pump unit (1.1.7 (d) (ii)) DANGEROUS

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front condensation in headlamp unit

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced outer sill end corroding (6.1.1 (c) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced Offside rear outer sill end corroding (6.1.1 (c) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing tyre outer sidewall (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing tyre outer sidewall (5.2.3 (d) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced Offside rear outer sill end corroding (6.1.1 (c) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing tyre outer sidewall (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing tyre outer sidewall (5.2.3 (d) (ii))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Tyre worn close to legal limit/worn on edge both front tyre tread depths wearing low on inner edges (5.2.3 (e))

Windscreen damaged but not adversely affecting driver's view windscreen cracked in top centre section (3.2 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Seat belt insecurely fixed to the vehicles structure (5.2.1a)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)