2013 Seat Leon

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

vehicle passed emissions test, no print out was produced due to clean emissions

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Integral body structure is deformed but structural rigidity is not significantly reduced outer sill (6.1.1 (a) (i))

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Integral body structure is deformed but structural rigidity is not significantly reduced outer sill (6.1.1 (a) (i))

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

NEARSIDE DOOR/SILL PANEL DAMAGED

NEARSIDE REAR TYRE SIDEWALL PERISHED

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)