1983 Audi Coupe

Fuel pipe/s corroded

Nearside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Offside Rear Rear wheel bearing has slight play (2.6.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both front sides of chassis have been welded and undersealed

both rear chassis near suspension areas have been heavily welded and undersealed

engine oil leak

front cross member is corroded but not with in a prebscribed area

nearside rear floor has been heavily welded and undersealed

raditor loose

Brakes imbalanced across an axle (3.7.B.5b)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear rear brake grabbing severely (3.7.A.5b)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Rear Body has a projection caused by corrosion (6.1.C.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3) DANGEROUS

Fuel pipe/s corroded

Nearside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Offside Rear Rear wheel bearing has slight play (2.6.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both front sides of chassis have been welded and undersealed

engine oil leak

front cross member is corroded but not with in a prebscribed area

nearside rear floor has been heavily welded and undersealed

raditor loose

both front brake discs slighly pitted

both front chassis have been welded and undersealed

front cross member is corroded but not with a prebscribed area

fuel pipes corroded

nearside rear floor has been heavily welded and undersealed

offside rear floor corroded but not within prebscribed area

oil leak

raditor loose

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear rear brake binding (3.7.B.1)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front front brake grabbing severely (3.7.A.2b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear rear brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.B.7)

front brake application uneven (3.7.B.2)

fuel pipes corroded

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

both front brake discs slighly pitted

front cross member is corroded but not with a prebscribed area

nearside rear floor has been heavily welded and undersealed

oil leak

raditor loose

Fuel pipe/s corroded

Oil leak

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both front discs slightly pitted

front chassis showing signs of corrosion

Centre Exhaust system not adequately supported (7.1.1)

Front Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Rear Exhaust system not adequately supported (7.1.1)

Fuel pipe/s corroded

Oil leak

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both front discs slightly pitted

front chassis showing signs of corrosion

Brake cable has wires broken but is not significantly weakened (3.5.1b)

Front Exhaust has part of the system slightly deteriorated (7.1.1a)

brake pipe metal ferrauls corroded

front inner wings corroding

fuel pipes corroded

Brake lever has restricted free movement (3.5.1k)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Obligatory mirror does not provide a view to the rear (8.1.2b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear rear brake grabbing severely (3.7.A.5b)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim too low (1.8)

Offside Obligatory mirror does not provide a view to the rear (8.1.2b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside rear brake grabbing severely (3.7.A.5b)

Rear Exhaust system not adequately supported (7.1.1)

Nearside Rear wheel bearing has slight play (2.6.2)

brake pipe metal ferrauls corroded

fuel pipes corroded

Front Brake hose ferrule excessively corroded (3.6.B.4e)

Hazard warning switch faulty (1.4.B.1d)

Offside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Rear Brake hose ferrule excessively corroded (3.6.B.4e)

Fuel pipe/s corroded

Brake load sensing valve linkage defective and function impaired (3.6.E.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Front registration plate character(s) likely to be misread (6.3.4b)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

Nearside Rear rear brake recording little or no effort (3.7.B.5a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp not working on main beam (1.7.5a)

Offside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear brake disc excessively scored (3.5.1h)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Outer Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Outer Front constant velocity joint gaiter deteriorated (2.5.C.1a)

fuel pipes corroded

under vehicle surface corrosion not to excess at time of test

various metal brake pipes surface corrosion

Nearside Front wheel bearing has excessive play (2.5.A.3c)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front constant velocity joint gaiter split (2.5.C.1a)