2003 Toyota Yaris

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected axle mounting area (5.3.6 (a) (ii)) DANGEROUS

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Lower Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

fuel filler pipes corroded

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Headlamp lens slightly defective beam image reduced (4.1.1 (b) (i))

Offside Headlamp lens slightly defective beam image reduced (4.1.1 (b) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Emissions unable to be completed due to major exhaust leak (8.2.1.2 (d))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Headlamp lens slightly defective beam image reduced (4.1.1 (b) (i))

Offside Headlamp lens slightly defective beam image reduced (4.1.1 (b) (i))

complete exhaust system heavily corroded

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Fuel Pipe/s corroded fuel filler pipes ()

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Brake performance not tested (1.2.1 (g))

Central Front Brake pipe leaking on an air braking system (1.1.11 (b) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Fuel Pipe/s corroded fuel filler pipes ()

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Tyre obviously under inflated (5.2.3 (l))

Axle swivel pins and bushes swivel pin and/or bush slightly worn both rear (5.1.2 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

fuel filler pipe corroded

Emissions not tested (8.2.1.2 (d))

Exhaust system insecure 2 front hangars insecure (6.1.2 (a))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength offside rear inner sill (5.3.6 (a) (i))

Windscreen wiper does not clear the windscreen effectively both front (3.4 (b) (ii))

Axle swivel pins and bushes swivel pin and/or bush slightly worn both rear (5.1.2 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

fuel filler pipe corroded

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill corroded and holed within 30cm of a suspension component mounting (5.3.6 (a) (i))

Offside Rear Wheel bearing has excessive play Also rough when rotated (5.1.3 (a) (i))

Corrosion on under body of vehicle

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Exhaust mounting defective Both sides (6.1.2 (a))

Fuel filler pipes excessively corroded

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Bushes perished (5.3.4 (a) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn Both (5.1.2 (b) (i))

Tyre worn close to legal limit/worn on edge All 4 3mm and perished (5.2.3 (e))

Vehicle structure has slight corrosion rear inner sill aera (6.1.A.1)

Exhaust system not adequately supported (7.1.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear coil spring broken (2.4.C.1a)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. 24% (3.7.B.5b)

Nearside Inner Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Rear Vehicle structure has slight corrosion (6.1.B.2)

fuel filler pipes corroded

both rear tyres are cracking on side walls

fuel filler pipe corrodied but satisfactory for test

Offside Front constant velocity joint is slightly worn (2.5.C.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)