2004 Ford Focus C-max

Headlamp aim projected beam image is obviously incorrect both (4.1.2 (c))

Nearside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Headlamp levelling device inoperative (4.1.5 (a))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

engine management light ion

Nearside Headlamp has a product on the lens so that the light output is severely reduced (1.7.5a)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Headlamp has a product on the lens so that the light output is severely reduced (1.7.5a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

engine management light ion

Rear registration plate faded but not likely to be misread (6.3.1d)

Front Windscreen wiper does not clear the windscreen effectively Both side (8.2.2)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Rear registration plate faded but not likely to be misread (6.3.1d)

Nearside Stop lamp not working (1.2.1b)

Offside Rear position lamp(s) not working (1.1.A.3b)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

advise o/s/f & n/s/f wheel bearings slightly rough when rotated

Rear Registration plate lamp not working (1.1.5c)