2005 Volkswagen Golf

Nearside Front Side repeater not working (4.4.1 (a) (ii))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Front Side repeater not working mirror (4.4.1 (a) (ii))

Offside Headlamp aim too high (4.1.2 (a))

Engine mounting damaged but not to excess dog bone worn (6.1.8 (a) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Front Brake pad(s) wearing thin both (3.5.1g)

Nearside Front tyre cut outer wall

Nearside Inner Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Rear position lamp(s) damaged, but still visible from a reasonable distance (1.1.A.3d)

Offside Front coil spring broken (2.4.C.1a)

inner front brake pad appears slightly low

osf suspension top mount damaged

centre stop lamp not working

osf outer cv gaitor has slight seepage of grease

Offside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (4.1.E.2a)