MOT Status
ExpiredMileage
139,988 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Nearside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))
Nearside Front Position lamp not working (4.2.1 (a) (ii))
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))
Nearside Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill area (5.3.6 (a) (i))
Offside Front Position lamp not working (4.2.1 (a) (ii))
Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))
Offside Parking brake inoperative on one side (1.4.1 (a))
Offside Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))
Parking brake efficiency below requirements (1.4.2 (a) (i))
Windscreen washer provides insufficient washer liquid (3.5 (a))
Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))
Nearside Rear Road wheel slightly distorted (5.2.2 (c) (i))
Offside Front Road wheel slightly distorted (5.2.2 (c) (i))
Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Front Brake pad(s) wearing thin (1.1.13 (a) (ii))
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))
Nearside Rear Suspension component mounting prescribed area damaged but not considered excessive (5.3.6 (a) (i))
Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))
Offside Rear Service brake binding but not excessively (1.2.1 (f))
Oil level on minimum
Power steering component has slight seepage from a component Steering rack (2.1.5 (a))
Rear Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))
Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))
Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill (marked with chalk) (5.3.6 (a) (i))
Front Brake pad(s) wearing thin (1.1.13 (a) (ii))
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))
Nearside Rear Suspension component mounting prescribed area damaged but not considered excessive (5.3.6 (a) (i))
Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))
Offside Rear Service brake binding but not excessively (1.2.1 (f))
Oil level on minimum
Power steering component has slight seepage from a component Steering rack (2.1.5 (a))
Rear Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))
Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))
Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))
Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))
Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))
Vehicle structure is corroded but structural rigidity is not significantly reduced rear chassis legs have surface corrosion (6.1.1 (c) (i))
Nearside Headlamp aim projected beam image is obviously incorrect headlamp glazed (4.1.2 (c))
Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))
Offside Headlamp aim projected beam image is obviously incorrect headlamp glazed (4.1.2 (c))
Offside Rear Passenger's seat backrest cannot be secured in the upright position. (6.2.6 (a) (i))
Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))
Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))
Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))
Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))
Vehicle structure is corroded but structural rigidity is not significantly reduced rear chassis legs have surface corrosion (6.1.1 (c) (i))
Nearside Front Direction indicator incorrect colour (4.4.3 (a))
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))
Offside Front Direction indicator incorrect colour (4.4.3 (a))
Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))
Offside Rear reflector missing (4.8.2 (a) (ii))
Exhaust emits excessive smoke or vapour but not likely to obscure the vision of other road users (8.2.2.2 (c))
Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))
Nearside Rear Coil spring corroded (5.3.1 (b) (i))
Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))
Offside Rear Coil spring corroded (5.3.1 (b) (i))
Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Oil leak, but not excessive (8.4.1 (a) (i))
Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))
Rear Registration plate insecure but not likely to fall off (0.1 (a))
Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))
Nearside Front Windscreen washer provides insufficient washer liquid (3.5 (a))
Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))
Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))
Offside Front Windscreen washer provides insufficient washer liquid (3.5 (a))
Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))
Exhaust emits excessive smoke or vapour but not likely to obscure the vision of other road users (8.2.2.2 (c))
Exhaust heat shields insecure
Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))
Nearside Rear Coil spring corroded (5.3.1 (b) (i))
Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Rear Coil spring corroded (5.3.1 (b) (i))
Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Oil leak, but not excessive (8.4.1 (a) (i))
Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))
Rear Registration plate insecure but not likely to fall off (0.1 (a))
Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Central Front Exhaust box corroding
Exhaust heat shield deteriorated & loose
Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Rear Brake disc worn, pitted or scored, but not seriously weakened Both (1.1.14 (a) (ii))
Headlamp aim not tested (4.1.2 (b))
Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))
Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))
Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))
Central Front Exhaust box corroding
Exhaust heat shield deteriorated & loose
Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Rear Brake disc worn, pitted or scored, but not seriously weakened Both (1.1.14 (a) (ii))
Nearside Front Inner Tyre worn close to the legal limit (4.1.E.1)
Nearside Rear Inner Tyre worn close to the legal limit (4.1.E.1)
Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Offside Rear Inner Tyre worn close to the legal limit (4.1.E.1)
Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Nearside Rear Tyre worn close to the legal limit (4.1.E.1)
Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)
Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)
Nearside Front Tyre worn close to the legal limit (4.1.E.1)
Offside Front Tyre worn close to the legal limit (4.1.E.1)
Nearside Front Tyre worn close to the legal limit (4.1.E.1)
Offside Front Tyre worn close to the legal limit (4.1.E.1)
Offside Registration plate lamp not working (1.1.C.1d)
both front discs slightly worn
How Reliable is the Ford Focus C-max?
Based on 1,326,487 MOT tests across 79,932 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
EN06 AZB is a 2006 Ford Focus C-max in Black with a 1,997cc diesel engine. This vehicle has been through 23 MOT tests with a personal pass rate of 65.2%.
Across all 2006 Ford Focus C-max models, the average MOT pass rate is 73.4% with a typical mileage of 70,386 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Ford Focus C-max fails its MOT is tyre tread depth below requirements of 1.6mm, accounting for 67,238 recorded failures. If you're considering buying EN06 AZB, it's worth having these areas checked by a mechanic before committing.
The Ford Focus C-max typically stays on UK roads for around 23 years. At 20 years old, this Ford Focus C-max is approaching the upper end of the typical lifespan for this model.
Frequently Asked Questions
How do I check the history of EN06 AZB?
You can check the full history of EN06 AZB by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was EN06 AZB registered?
EN06 AZB is a 2006 Ford Focus C-max, first registered on 27 June 2006.
Is EN06 AZB safe to buy?
The MOT history for EN06 AZB shows 23 tests with a 65.2% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does EN06 AZB have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on EN06 AZB. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.