2006 Ford Ka

Nearside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Vehicle structure is repaired but structural rigidity is not significantly reduced floor pan (6.1.1 (d) (i))

Offside Front Vehicle structure is repaired but structural rigidity is not significantly reduced floor pan (6.1.1 (d) (i))

Nearside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Vehicle structure is repaired but structural rigidity is not significantly reduced floor pan (6.1.1 (d) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Vehicle structure is repaired but structural rigidity is not significantly reduced floor pan (6.1.1 (d) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen washer not working (3.5 (a))

Brake fluid warning lamp illuminated (1.1.10 (f))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Bumper insecure (6.1.4 (a) (i))

Front Suspension arm pin or bush excessively worn Both side (5.3.4 (a) (i))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp aim too low (4.1.2 (a))

Oil leaking excessively from engine (8.4.1 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps Both side (4.7.1 (b) (ii))

Body / Vehicle structure has slight corrosion

Gearbox mounting defective ()

Registration plate insecure but not likely to fall off front and rear (0.1 (a))

Exhaust system not adequately supported (7.1.1)

front tyres wearing more on inner edges

nearside front tyre starting to wear low 3mm

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Stop lamp not working (1.2.1b)

Offside Stop lamp not working (1.2.1b)

engine management light on

front tyres wearing more on inner edges

nearside front tyre starting to wear low 3mm

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

E.M.L on

E.M.L on

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2) DANGEROUS

EML on

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim not tested (1.8.A.1c)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear position lamp(s) not working (1.1.A.3b)

Front Brake pad(s) wearing thin (3.5.1g)

both front tyres starting to wear on edges

nearside front tyre is starting to perish on sidewall

nearside rear tyre is starting to perish on sidewall