2008 Mercedes-benz Vito

Front Inner Anti-roll bar pin or bush worn but not resulting in excessive movement mount both sides (5.3.4 (a) (i))

Offside Front Upper Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis and lower arms both sides (5.3.6 (a) (i))

Nearside front tyre tread worn low on outer shoulder.

Offside Front Obligatory mirror slightly damaged door (3.3 (b) (i))

Offside Front Upper Anti-roll bar linkage ball joint dust cover severely deteriorated and lower (5.3.4 (b) (i))

Offside Rear Coil spring corroded at bottom (5.3.1 (b) (i))

Parking brake travel getting long

Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis both sides (5.3.6 (a) (i))

handbrake performance poor

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Front Inner Road wheel slightly distorted (5.2.2 (c) (i))

Nearside front tyre cracking

Rear exhaust has a crack in tail pipe

Tow bar socket has no cover

Nearside Front Service brake lagging in operation (1.2.1 (d))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Tow bar socket has no cover

Park brake performance just in limit and lever has little reserve traval

Tow bar electrical socket has no cover

Exhaust has a major leak of exhaust gases (7.1.2)

o/s/r tyre worn on inside edge also has small cuts in tread

Front Brake pad(s) wearing thin (3.5.1g)

Parking brake lever has little reserve travel (3.1.6b)

pad warning light on

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)