2010 Hyundai I30

Brake hose has slight corrosion to ferrule all unchanged (1.1.12 (f) (i))

Brake pipe corroded, covered in grease or other material all unchanged (1.1.11 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Suspension arm pin or bush worn but not resulting in excessive movement both front (5.3.4 (a) (i))

Anti-roll bar pin or bush worn but not resulting in excessive movement both front (5.3.4 (a) (i))

Brake hose has slight corrosion to ferrule all unchanged (1.1.12 (f) (i))

Brake pipe corroded, covered in grease or other material all unchanged (1.1.11 (c))

Brake hose has slight corrosion to ferrule all 4 (1.1.12 (f) (i))

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Emissions not tested due to exhaust (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Nearside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Wheel bearing play so excessive it is likely to break up (5.1.3 (a) (ii)) DANGEROUS

Nearside Front Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) DANGEROUS

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Exhaust has a major leak of exhaust gases front pipe flexi (6.1.2 (a))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps both rear (4.7.1 (b) (ii))

Brake pad(s) less than 1.5 mm thick All front (1.1.13 (a) (ii)) DANGEROUS

Stop lamp(s) all not working All rear (4.3.1 (a) (iii)) DANGEROUS

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Rear rear brake recording little or no effort (3.7.B.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar has slight play in a ball joint (2.4.G.2)