2013 Ford S-max

Central Rear Exhaust mounting defective (6.1.2 (a))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

undertray fitted

Offside Rear Suspension arm pin or bush likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Central Rear Exhaust mounting defective (6.1.2 (a))

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

undertray fitted

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive Arm - Spring mount (5.3.6 (a) (i))

Offside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive Arm - Spring mount (5.3.6 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive Arm - Spring mount (5.3.6 (a) (i))

Offside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive Arm - Spring mount (5.3.6 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake performance not tested (1.2.1 (g))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))