2002 Ford Ka

Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Dipswitch operation does not extinguish all main beam headlamps leaving at least one pair of dipped beam headlamps (4.1.3 (b))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Rear Suspension arm pin or bush excessively worn trailing arm (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Suspension arm pin or bush excessively worn trailing arm (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm 165/65/14 (5.2.3 (e)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Windscreen wiper blade defective o/s & n/s (3.4 (b) (i))

Headlamp switch does not immediately illuminate all main beam headlamps (4.1.3 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive chassis (7.1.1 (a) (i))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis leg (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive floor pan (5.3.6 (a) (i))

Nearside Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive chassis (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive floor pan (5.3.6 (a) (i))

Offside Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear exhaust fowling rear bumper

no oil or coolant at time of test

Bonnet cannot be secured in the closed position body damage (3.1 (b) (i))

Front Service brake excessively fluctuating n/s 15 kgf o/s 30 kgf (1.2.1 (e))

Rear Service brake effort inadequate at a wheel N/S 71 kgf O/S 64 kgf (1.2.1 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Windscreen wiper blade defective o/s & n/s (3.4 (b) (i))

Headlamp switch does not immediately illuminate all main beam headlamps (4.1.3 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive chassis (7.1.1 (a) (i))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis leg (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive floor pan (5.3.6 (a) (i))

Nearside Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive chassis (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive floor pan (5.3.6 (a) (i))

Offside Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear exhaust fowling rear bumper

no oil or coolant at time of test

Nearside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak ()

Rear Brake hose slightly deteriorated both (3.6.B.4d)

engine had no oil prior to mot

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

Nearside Headlamp aim too low (1.8)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too low (1.8)

rear brake recording little or no effort (3.7.B.5a)

Nearside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak ()

Rear Brake hose slightly deteriorated both (3.6.B.4d)

engine had no oil prior to mot

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Road wheel slightly damaged (4.2.A.1a)

oil leak

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Road wheel with a slightly distorted bead rim (4.2.A.1a)

Oil leak

bonnet s-catch stiff operation

front tyres cracking and worn on edges

spare worn

Nearside Rear position lamp(s) not working (1.1.A.3b)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Rear Brake hose slightly deteriorated (3.6.B.4d)

Offside Road wheel with a slightly distorted bead rim (4.2.A.1a)

Oil leak

bonnet s-catch stiff operation

front tyres cracking and worn on edges

spare worn

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Oil leak

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Oil leak

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Oil leak

eng oil low

Nearside Headlamp aim not tested (1.8.A.1c)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp aim too low (1.8)

Offside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Stop lamp not working (1.2.1b)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Oil leak

eng oil low

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Inner Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Oil leak

Power steering component(s) has slight seepage from a component (2.3.3b)

wheel trims fitted

Nearside Rear coil spring incomplete (2.4.C.1a)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear coil spring incomplete (2.4.C.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Inner Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Oil leak

Power steering component(s) has slight seepage from a component (2.3.3b)

wheel trims fitted

Offside Front Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

o/s washer jet req; cleaning out

Nearside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c) DANGEROUS

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Offside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c) DANGEROUS

Offside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

n/s front tyre showing slight cracks to sidewalls and wear on tread edges.

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

brake fliud low

offside front tyre wearing out of shape