2003 Peugeot 206

Brake load sensing valve inoperative but ABS functioning (1.1.17 (c) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Brake master cylinder/servo mounting prescribed area is excessively corroded bulkhead (1.1.21 (e) (i))

Nearside Rear Service brake lagging in operation (1.2.1 (d))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive inner wings and sill to floors (5.3.6 (a) (i))

both rear bump stop brackets corroded

slight play in offside rear radious arm

Oil leak, but not excessive (8.4.1 (a) (i))

Front Power steering pipe/hose leaking (2.1.5 (a))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Nearside Front Anti-roll bar ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Offside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Exhaust system not adequately supported (7.1.1)

Offside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Offside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Child seat fitted not allowing full inspection of adult belt

Off-side drive shaft noisy when rotated

Offside inner cv joint worn

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Brake load sensing valve linkage seized (3.6.E.3)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside inner cv joint worn

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

offside drive shaft inner joint noisey

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

offside drive shaft inner joint noisey

slight blow from join of exhaust backbox