2003 Ford Ka

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Front passenger door cannot be opened from outside the vehicle (6.2.3 (a))

Nearside Rear Suspension arm pin or bush excessively worn trailing arm (5.3.4 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Suspension arm pin or bush excessively worn trailing arm (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Front Tyre has a lump, caused by separation or partial failure of its structure inner edge (5.2.3 (d) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside Front Tyre worn close to legal limit/worn on edge inner edge on limit (5.2.3 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Position lamp not working (4.2.1 (a))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Brake actuating linkage mounting prescribed area is corroded but not considered excessive (3.3.A.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear position lamp(s) not working (1.1.A.3b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Brake actuating linkage mounting prescribed area is corroded but not considered excessive (3.3.A.2)

Engine MIL illuminated

Nearside Front Lower Suspension arm has slight play in a pin/bush Rear bush (2.4.G.2)

Offside Brake actuating linkage mounting prescribed area is corroded but not considered excessive (3.3.A.2)

Offside Front Lower Suspension arm has slight play in a pin/bush Rear bush (2.4.G.2)

Nearside Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Offside Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Power steering component(s) leaking (2.3.3b)

Engine MIL illuminated

Nearside Front Lower Suspension arm has slight play in a pin/bush Rear bush (2.4.G.2)

Offside Brake actuating linkage mounting prescribed area is corroded but not considered excessive (3.3.A.2)

Offside Front Lower Suspension arm has slight play in a pin/bush Rear bush (2.4.G.2)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nearside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Offside Front Lower Ball joint dust cover damaged, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Power steering component(s) has slight seepage from a joint (2.3.3b)

Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Front Lower Ball joint dust cover damaged, but preventing the ingress of dirt (2.2.C.1c)

Offside Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Headlamp aim too low (1.8)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp not working on dipped beam (1.7.5a)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Windscreen washer provides insufficient washer liquid (8.2.3)