2003 Mazda Tribute

Exhaust system insecure Center insecure and rear silencer tail pipe broken off (6.1.2 (a))

Hazard warning switch inoperative (4.4.2 (a) (ii))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area damaged to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Suspension spring mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected Wheel arch area (5.3.6 (a) (ii)) DANGEROUS

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material Rear ends of both front and rear brake pipes (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive Both offside and nearside rear inner sill sections surface corrosion (5.3.6 (a) (i))

Front Registration plate does not conform to the specified requirements characters too small (0.1 (d))

Nearside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wheel arch (6.1.1 (c) (i))

Offside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner and outer sill (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wheel arch (6.1.1 (c) (i))

Rear Rear reflector defective or damaged by more than 50% of the reflecting surface both tinted (4.8.1 (a) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Exhaust has a minor leak of exhaust gases X2 (6.1.2 (a))

Front Brake disc worn, but not excessively both (1.1.14 (a) (i))

Front Brake pad(s) wearing thin Replace ASAP (1.1.13 (a) (ii))

Front Window excessively tinted but not adversely affecting driver's view both (3.2 (b) (i))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material X2 (1.1.11 (c))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Rear Oil leak, but not excessive differential (8.4.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

exhaust rear joint excessively deteriorated

rear lights tinted

sill covers fitted as standard not allowing a full inspection

under body slightly corroded in areas

Front Horn not working (7.7 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Rear Body has slight corrosion (6.1.B.2)

Offside Rear Body has slight corrosion (6.1.B.2)

rear exhaust hanger corroded

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

Brake performance not tested (3.7.A.1)

Nearside Front Brake hose excessively deteriorated (3.6.B.4d)

Nearside Rear Brake hose excessively deteriorated (3.6.B.4d)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Brake hose excessively deteriorated (3.6.B.4d)

Offside Rear Brake hose excessively deteriorated (3.6.B.4d)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.C.1b)

Service brake: efficiency below requirements (3.7.C.1a)

(1)front discs corroded (2) exhaust rusty & metal shields rattleing

Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Centre Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Headlamp aim too low (1.8)

Centre Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

both rear tyres on 4mm

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

both rear tyres on 4mm

Nearside Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)