2010 Kia Picanto

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Tyre slightly damaged/cracking or perishing both front tyres perishing around the edges (5.2.3 (d) (ii))

Offside Front Road wheel slightly distorted inner edge (5.2.2 (c) (i))

Front Brake hose has slight corrosion to ferrule both sides by the caliper (1.1.12 (f) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides are showing signs of wear in the rubber bushes (5.3.4 (a) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated inner CV joint is weeping grease slightly (6.1.7 (g) (i))

Offside Front Brake pipe corroded, covered in grease or other material in wheel arch where it joins to the flexi hose is corroding (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material both sides in the wheel arch's where they join to the flexi hose's are starting to corrode (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive by the rear beam axle mounting on both sides just in front of the mounts is corroding on the surface (5.3.6 (a) (i))

Tyre slightly damaged/cracking or perishing nearside & offside rear tyres are cracking & perishing (5.2.3 (d) (ii))

slight play in the nearside front top mount bush / bearing

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

slight play in the nearside front top mount bush / bearing

Front Inner Brake pad(s) wearing thin (3.5.1g)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Parking brake lever has little reserve travel (3.1.6b)

exhaust front mount deteriorated

front exhaust mount deteriorated

front exhaust mounting bracket is deteriorated, but still supporting the exhaust

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too low (1.8)

front exhaust mounting bracket is deteriorated, but still supporting the exhaust

Nearside Front wheel bearing has slight play (2.5.A.3c)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)