2002 Mazda MX-5

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Service brake lagging in operation (1.2.1 (d))

Nearside Front Suspension arm pin or bush excessively worn lower arm rear bush (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength boot floor area (marked with chalk) (5.3.6 (a) (i))

Offside Rear Brake pipe excessively corroded front to rear (marked ) (1.1.11 (c))

Rear Exhaust emissions likely to be affected by an exhaust leak mid/rear section joint blowing (8.2.1.1 (b))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Brake pipe slightly corroded front to rear (3.6.B.2c)

Nearside Front tyre in poor condition

underneath of vehicle corroded

Nearside Front Anti-roll bar insecure (2.4.G.1)

Nearside Front Brake pad(s) less than 1.5 mm thick inner pads (3.5.1g)

Brake pipe slightly corroded front to rear (3.6.B.2c)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front tyre in poor condition

underneath of vehicle corroded

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

front brake application uneven (3.7.B.2)

Nearside front brake binding (3.7.B.1) DANGEROUS

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Under-trays fitted obscuring some underside components

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Under-trays fitted obscuring some underside components

Offside Rear Anti-roll bar has slight play in a ball joint (2.4.G.2)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

all rear brake pipes corodding

Engine covers fitted obscuring some components in the engine bay

Nearside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Engine covers fitted obscuring some components in the engine bay

Both front tyres wearing on shoulder areas, nearside front tyre badly cracking and perishing

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front brake disc excessively pitted (3.5.1h)

Front front brake juddering severely (3.7.A.2b)

Offside Outer Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear brake disc excessively pitted (3.5.1h)

Both front tyres wearing on shoulder areas, nearside front tyre badly cracking and perishing

Rear Brake pad(s) wearing thin (3.5.1g)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Inner Front brake disc slightly pitted (3.5.1h)

Rear Brake pad(s) wearing thin (3.5.1g)

all four tyres slightly cracked/perished

Nearside Front brake disc slightly pitted (3.5.1h)

Offside Front brake disc slightly pitted (3.5.1h)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)