2006 Toyota Aygo

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Registration plate insecure but not likely to fall off (0.1 (a))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Brake lever not releasing correctly and functionality of brakes affected (1.1.2 (b) (ii))

Emissions unable to be completed (8.2.2.2 (e))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Registration plate insecure but not likely to fall off (0.1 (a))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Exhaust has a minor leak of exhaust gases Back box (6.1.2 (a))

Exhaust emits blue smoke during acceleration (8.2.1.2 (g))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Outer Integral body structure is repaired but structural rigidity is not significantly reduced sill (6.1.1 (d) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

Rear Upper Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security both inner sills and prescribed areas (6.2.2 (d) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust emits dense blue smoke at idle (8.2.1.2 (f))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Rear Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill yellow marked (6.1.1 (c) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

Rear Upper Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security both inner sills and prescribed areas (6.2.2 (d) (i))

Front Headlamp has a product on the lens but not seriously reducing light output Both Sides (4.1.4 (b))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear (5.3.4 (a) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear (5.3.4 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Rear Service brake excessively binding (1.2.1 (f))

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

oil leak

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Offside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Registration plate lamp not working (1.1.C.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Tyre tread depth below requirements of 1.6mm (4.1.E.1)