2005 Ford Focus C-max

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust emits excessive dense blue smoke during acceleration (8.2.1.2 (g))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Registration plate inscription illegible (0.1 (b))

Nearside Front Lower Suspension arm pin or bush excessively worn rear (5.3.4 (a) (i))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Offside Front Lower Suspension arm pin or bush excessively worn rear (5.3.4 (a) (i))

Offside Rear Lower Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Wheel bearing play so excessive it is likely to break up (5.1.3 (a) (ii)) DANGEROUS

Offside Rear Child Seat fitted not allowing full inspection of adult belt ()

front and rear suspension components heavily rusted

Front Headlamp deteriorated but light output not reduced both (1.7.5a)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Emissions not tested Rear silencer leaking (7.3.A.1)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement Rear bush (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Headlamp not working on main beam (1.7.5a)

Nearside Rear rear brake excessively fluctuating (3.7.B.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Front wheel bearing rough when rotated (2.5.A.2)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement Rear bush (2.4.G.2)

Offside Rear rear brake excessively fluctuating (3.7.B.3)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Exhaust has a major leak of exhaust gases silencer (7.1.2)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

brake disc worn, pitted or scored, but not seriously weakened Both rear (3.5.1i)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement Rear bush (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement Rear bush (2.4.G.2)

Offside front and Nearside front tyres worn on inner edge

Front Exhaust system not adequately supported (7.1.1)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement Rear bush (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement Rear bush (2.4.G.2)

Offside front and Nearside front tyres worn on inner edge

Nearside Inner Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Outer Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Inner Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Stop lamp not working (1.2.1b)

Front Direction indicator slightly discoloured (1.4.A.2f)

Front brake imbalance 23% (MAX 25%)

Rear Direction indicator slightly discoloured (1.4.A.2f)