2002 Mazda MX-5

Brake pipe corroded, covered in grease or other material front and rear (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Offside Front Anti-roll bar linkage insecurely attached (5.3.3 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

surface corrosion to underside of vehicle

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Emissions not tested misfire under load (8.2.1.2 (d))

Front Sub-frame attachment bracket/mounting insecure both rear fixing bolts missing (5.3.3 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis leg in engine bay and wheel arch (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength and outer sill (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis leg in engine bay and wheel arch (5.3.6 (a) (i))

Offside Front Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Front Lower Suspension arm ball joint dust cover severely deteriorated both (5.3.4 (b) (i))

Nearside Front caliper damp

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner and outer sill (5.3.6 (a) (i))

Offside Rear parking brake low effort

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

engine management light staying on

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

engine management light staying on

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Offside Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced both sides (6.1.1 (c) (i))

Rear Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Nearside front brake binding (3.7.B.1)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Rear Brake pad(s) wearing thin (3.5.1g)

Lower Front suspension ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Registration plate lamp not working (1.1.C.1d)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

front tyres worm outer edges

Offside Front position lamp(s) not working (1.1.A.3b)

front tyres worm outer edges

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)